Printing/Exporting Notes with Bible verse references with or without text

Eugene Nowak

I can’t seem to figure out how to: 1) selectively show verse reference &/or verse text for Note Anchors; 2) Print/Export Notes showing verse reference &/or verse text.  Show Full Anchor Text is selected in all the following cases.

CASE 1

Select the verse text and select the highlight directly from the open pallet, the Anchor with the verse reference and text is shown in the Note

If attempt to Print/Export the Note, only get the verse text without the verse reference.

CASE 2

Select the verse text, and then right click

Choosing the last highlight icon, get just the verse reference in the Note, but no text.

Print/Export the Note, just the verse reference and not the verse text.

CASE 3

Add an Anchor, after adding a highlight from the sub panel selected to Add another Anchor

Selecting Print/Export, get the verse reference and not verse text for either Anchor.

CASE 4

Select the verse, then added the highlight from the Highlight Panel, get the verse reference and text like before.  But if Add another Anchor, just get the verse reference.

And in the Print/Export Panel, get the verse text with no reference, and just the verse reference for the added Anchor.

CASE 5

Adding another Anchor to the Note, but instead of adding it as a reference, adding the Anchor based on selected Bible text.  Existing Note has 2 Anchors already.

Adding a 3^rd Anchor based on Selected Text.

But, when Print/Export is selected for that Note, only text is shown with no corresponding Bible reference, just like in other cases.

 

Have looked thru the Program Settings; reviewed training videos; looked thru Helps, Wiki, Forums, etc. but no good.  Tried every combination I can think of, what am I missing?

Any suggestions, other than cut and paste into external Logos document.

MJ. Smith

Basically, notes come in two forms:

• by reference i.e. the anchor shows as a reference and can be shown in any resource indexed by that reference type
• by selection i.e. the ancho shows as a selection of text from a specific resource and shows only in that resource.

The Add anchor function simply defines which of the above is created.

The Show full anchor text  IIRC applies only within the note tool.

To the best of my knowledge, the function you want is not available in Logos, although I would love to be proven wrong. The work around is to copy the text into the note itself.