Bug: A certain movement in the sentece diagram tool causes L4 to crash

Description

I was in the middle of diagramming a passage, selected the squiggly line tool (circled in red above), and when I tried to manipulate it a certain way the program would crash. I repeated it 3 or 4 times with the same result.

Steps to reproduce

Set up a text-flow diagram of Rom 3.19-31 with NA27.
Lay it out as in the screen shot above.
Select the squiggly line tool and put it as shown.
Grab the center of the line, marked #1.
Move it upwards all the way (#2).
L4 crashes, instead of just adjusting the shape.

System specs

Find more posts tagged with

Comments

Hunter Clagett

Does this happen every time you perform that action?

I have been unable to reproduce those results.

Thanks,

Room4more

https://community.logos.com/discussion/comment/364971#Comment_364971

Does this happen every time you perform that action?

I have been unable to reproduce those results.

Thanks,

I could not either. but the center maker will not or is not allowed to go beyond the restraints of the end of the curvatures. Also, not sure what the intention is for the reconstruct of the curvature.

MJ. Smith

I repeated it 3 or 4 times with the same result.

Did you try is in a new document? What I'm thinking is that there may be something corrupted in the document rather than in the processing. If so, perhaps Bradley can ask you to provide the db containing the diagram.

Keep Smiling 4 Jesus :)

System specs

Netbook | HP Pavilion dm1 | Windows Experience Index 3.6 | AMD E-350 1.60 GHz | 4GB RAM | Windows 7 Home Premium 64-bit Service Pack 1 | connected to auxiliary 22" AOC monitor for double monitor use.

Wonder if setting affinity for Logos 4 affects crash ?

Setting affinity was a workaround for Logos 4 indexing crash issue using AMD CPU's in thread => http://community.logos.com/forums/p/35501/275641.aspx#275641

Keep Smiling [:)]

Stefán Féliz-Kent

https://community.logos.com/discussion/comment/364971#Comment_364971

Yep, every time.

Stefán Féliz-Kent

https://community.logos.com/discussion/comment/365084#Comment_365084

Did you try is in a new document? What I'm thinking is that there may be something corrupted in the document rather than in the processing. If so, perhaps Bradley can ask you to provide the db containing the diagram.

I have not tried it in a new document. That could be it. I'll check it out.

Thanks everyone.