Logos 5 mac crossgrade: Louw Nida no longer in reverse interlinear!

My mac Logos 5 cross grade has removed Louw-Nida coding from the reverse interlinears! This was my most frequent use of the reverse interlinear! Am I an isolated case, or has anyone else had this issue? If so, have you been able to get the feature back?

Find more posts tagged with

Comments

SteveF

Could you show a screen shot?

Have you tried right clicking over the Reverse interlineaar highlights--you might be able to "turn it on" that way?

JT (alabama24)

https://community.logos.com/discussion/comment/435153#Comment_435153

Also, if Steve's advice doesn't work, make sure you are in the NT! [;)]

Fr. Charles R. Matheny

https://community.logos.com/discussion/comment/435154#Comment_435154

Bryan is correct and, I am fairly upset about this as well.

Bryan, you can see Louw-Nida if you go to "inline" mode in the "display" drop down box, but that is the only way I have found.

Do not like it I don't !

Would really like it better if this feature was back to the way it was, much more useful to me.

Blessings.

MJ. Smith

https://community.logos.com/discussion/comment/435158#Comment_435158

Would really like it better if this feature was back to the way it was, much more useful to me.

Somewhere I've gotten lost.- I can set either the inline or the bottom ribbon to show or not show LN, which I thought was the way it worked in L4. What am I missing?

JT (alabama24)

https://community.logos.com/discussion/comment/435162#Comment_435162

What am I missing?

I think I am lost too… Here are some screen shots. Are you wanting something different?

Bryan Tucker

https://community.logos.com/discussion/comment/435166#Comment_435166

Resolved. Thanks for tipping me off on the screen shot. Rt clicking on the left column of Reverse Interlinear pane allowed me to reselect LN for display. For some reason the install had disabled it. As I finished my study for tomorrow I resorted to rt clicking individual words & opening the LN entry. Much more convenient to hover & read. Thanks for the help.

[:D]

Bryan Tucker

https://community.logos.com/discussion/comment/435158#Comment_435158

See resolution below. Just open your reverse interlinear & rt click on the left column. This should enable you to reselect LN for display. For some reason install bumped display of LN…not removing the feature as it appeared.[:D]

Bryan Tucker

https://community.logos.com/discussion/comment/435153#Comment_435153

wasn't sure what you meant by "Reverse interlinear highlights"…but the screenshot from another poster helped me realize you were talking about the far left column. It worked. Thanks!

Cynthia in Florida

https://community.logos.com/discussion/comment/435166#Comment_435166

Thank you for this. My Mac did the same thing, and I wondered where it went but had little energy to figure it out!