Page 1 of 1 (5 items)
This post has 4 Replies | 1 Follower

Posts 24
Donald Kurz | Forum Activity | Posted: Sat, Apr 21 2012 7:21 PM

today as we were working on a presentation, we noticed that during the pre-service loop, the signals sign was not showing up on the slide where we had inserted a signal. The notification was sent to my device, but no signal sign came up on the screen. This was on a mac. Any ideas?

Posts 29
LogosEmployee
Anton Antig | Forum Activity | Replied: Sun, Apr 22 2012 7:04 AM

Hello Donald,

 

That is quite strange. Was the signal notification missing during while you were editing and during the preview?

 

Anton Antig

Logos Technical Support

Posts 24
Donald Kurz | Forum Activity | Replied: Sun, Apr 22 2012 8:14 AM

Yes it was there in the preview, etc but not on the secondary displays. 

Posts 29
LogosEmployee
Anton Antig | Forum Activity | Replied: Sun, Apr 22 2012 8:53 AM

Hello Donald,

 

I was not able to replicate the problem you are getting in Proclaim. What version of Proclaim do you have installed? Additionally, have you tried restarting?

 

Anton Antig

Logos Technical Support

Posts 24
Donald Kurz | Forum Activity | Replied: Mon, Apr 23 2012 2:32 PM

Well after restarting the software, it did not do that again. Strange.

Page 1 of 1 (5 items) | RSS