Control "Enable Video Input" separately for each virtual screen

The setting "Enable Video Input" can be used to show a video feed behind a slide. The area for video is selected using the transparent areas of the slide.

This is really useful to display video from a camera on the screen in church.

However consider the case where as well as the main "Slides" output for display in church, there is a second virtual output "streaming" used to supply subtitles to a video live stream.

Normally the subtitles are superimposed on the video by making use of the transparency information in the "streaming" virtual screen output from Proclaim. However, if the "Enable video Input" setting is enabled the transparency information will not be available because it will have been replaced by the video input to Proclaim.

It would be extremely useful if "Enable Video Input" could be controlled separately for each virtual screen. ( The minimum requirement would be to have a setting to make it only apply to the "Slides" virtual screen).

Being able to apply the setting just to the "Slides" virtual output but not to the others would be so much more useful than the current situation where the setting affects all outputs.

1
1 votes

Submitted · Last Updated